The Weld Wakker
More tools should be named for what they do. Take Mayhew’s Dominator Weld Wakker — like the previously mentioned Seam Buster, you hear the name, take one look at the tool, and you know it’s used to break apart spot welds or bonded panels.
buy xanax online codMayhew heat treats and tempers the blade then sharpens both the end and edge. A soft, two-composite material covers the shaft to make a grip. The shaft extends all the way to the metal end cap, so striking the tool transfers the force to the seam to make a hole between panels. Striking the tool on the side drives the panels apart.
buy ambien no rxThirty bucks buys you a set of two Weld Wakkers: one 11-3/4″ long tool with a 1″ wide blade and a second 14-1/2″ long tool with a 1-1/4″ wide blade.
Weld Wakker [Mayhew Tools]
Street Pricing [Google Products]
Via Amazon [What’s This?]
2 Responses to The Weld Wakker
Leave a Reply to shopmonger Cancel reply
Recent Comments
Paul Johansen { I bought a faulty CS450 DualSaw on TradeMe recently, knowing it would not function correctly, but it cost me next to nothing so mustn't grumble.... } – Feb 11, 8:12 PM
Moira Davies { I have an old (possibly 1940's) Radius 52 blow torch (lamp) which belonged to my father. It needs some new spare parts like the bottom... } – Feb 09, 6:55 AM
Mine { Garbage. The "tines" fold over as soon as you start moving. Unless your ground is already tilled soft, in which case you don't need to... } – Feb 07, 7:29 AM
Marty Lasher { I would like to get my hands on a Base Extension p/n 58387 for my 997 7 1/4" Sawcat. Anybody got an extra one? mlasher... } – Feb 04, 8:19 PM
eddie { sams club? make ur own } – Jan 28, 9:09 PM
JOHN Arbelo { I agree.....the article was written seemingly without doing any actual research. At leasst pick one up and handle it. Thanks to the other reviewers who... } – Jan 28, 11:30 AM
Posts by Category
TM Post Archives
Do a lot of people still use these? or are more and more of us using a weld cutter….I have found that the weld cutter provides an eaiser re-install of a new panel or part,…….
But i do like the idea of haivng a purpose built tool for this, old chisels dull to easy, although again i would use an air hammer with a fine ground chisel…..but maybe there is not enough room in some cases for the hammer…….
Shopmonger
One of my crew brought in a similar Steck Tool to try on siding/roofing nails:
http://www.steckmfg.com/20015.htm
We found it a bit short for that application – and still rather use our old slate rippers