« Flickr Pool: A Real-Life Toolbox
Perfectly Square Cuts With A Reciprocating Saw »

Dealmonger: Center It Hole-Drilling Jig $12.90

By Nick Carter

Aircraft Spruce and Specialty is selling the Center It hole-drilling jig for $12.90.  The jig allows you to align a drill bit with the center of the vee-block jig, then place tubing or round stock in the jig and drill a cross-hole exactly on center — a pretty handy tool for work like this.

Center It Hole-Drilling Jig [Aircraft Spruce and Specialty]
Street Pricing [Google Products]


This entry was posted on Tuesday, September 30th, 2008 at 12:02 pm and is filed under Dealmonger, Drills/Bits. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

3 Responses to “Dealmonger: Center It Hole-Drilling Jig $12.90”

  1. Tim B. Says:
    September 30th, 2008 at 12:11 pm

    Or, alternatively:
    http://www.harborfreight.com/cpi/ctaf/displayitem.taf?Itemnumber=92046

    Very similar design (though obviously a little cheaper, $9.99 NOT on sale)… I’ve had one for quite a while (got it on sale at HF for 4.99), and the couple times I’ve had need to use it, no complaints!

  2. techieman33 Says:
    September 30th, 2008 at 12:53 pm

    I guess it might be worth it if you don’t have a welder, it would take seconds to make something to do the same job with scrap steel laying around most shops

  3. news 21.10.2008 « Botchjob Says:
    October 21st, 2008 at 7:41 am

    [...] man leider oft nur den Rohren herum anstatt da mal spanhebend tätig zu werden. Dieses kleine Helferlein, gefunden beim Toolmonger könnte da eine Hilfe sein, der Nachbau aus gewöhnlichem Halbzeug [...]

Leave a Reply